Shanghai Shangzhen Compressor Co., Ltd.
|
|
|
|
|
|
Shanghai Shangzhen Compressor Co., Ltd.

 
 

全活性炭过滤器Post-processing equipments - High pressure adsorption dryer

1. No heat-type adsorption dryerNo heat-type adsorption dryer
   Working principle:
   No heat dryer is a selective adsorption using an adsorbent characteristics of certain components, the adsorption of moisture in compressed air, in order to achieve the purpose of drying. As adsorbent to a certain time will be saturation equilibrium, must be regenerated with dry air to restore the adsorption drying capacity. No heat drying machine is used twin towers and the use of part of the drying gas itself down to near atmospheric pressure, As regeneration gas to its regeneration, the switching time for a fixed switch towers, thereby continuously provide a dry gas.
   Design of large capacity, ensure the exports of devices have a stable outlet dew point, able to adapt to the adsorbent aging and working load changes; key components selected domestic and international famous brands, to ensure continuous and reliable operation device; the whole machine skid-mounted out-of factory, to make the device to be advanced.
   Available configurations:
   1, molecular sieve
   2, dew point switching mode
   3, high dew point alarm, interlock
   4, before and after the filter is installed in the machine
   5, the liquid crystal display, configure the computer PC   
     communication interface
   Parameter:
   Entrance temperature:≤45℃
    Handling capacity:0.7-210.0m3/min
    Working pressure:1.0Mpa-42.0Mpa
    Pressure dew point:-50℃
    Regenerative way:heatless regeneration
    Regenerative gas consumption :12%(in standard condition)
    Control system:CPU(standard configuration)
    Working system:A、B tower automatic switching,continuous working
    Cycle time :4-10min adjustment
    Condensate water outlet:Rc1/2" (Timing automatic electronic valve )
    Installation: In door installation on no base

2. Micro heat dryerMicro heat dryer
   Working principle:
   Micro heat drying machine is used twin pressure swing adsorption, micro-thermal regeneration process, the dry air with decompression expansion will be heated to a certain regeneration temperature when you do the regeneration operation, so that to make the regeneration gas gain a larger desorbing capability, reducing regeneration gas. The working principle of micro heat drying machine is that an adsorption tower in the adsorption drying under pressure, while the corresponding absorption tower from the main road to extract a small amount of compressed air after decompression and heating process, as its regeneration gas to micro-thermal regeneration. The desiccant after micro thermal regeneration, the residual water content has a more significant reduction, improve the processible capacity of the device .
    Device Features:
    Product gas consumption rate of about 6%, with energy saving features Long-cycle switching mode, the whole overall performance is good the key parts adopt famous brand, to ensure continuous and reliable operation device Electric heater with thermostat protection, to avoid burning heating elements
    Available configurations:
    1, zeolite molecular sieves or activated alumina +
    2 bunk beds, dew point switching mode
    3, high dew point alarm, interlock
    4, the heating temperature set double interlock
    5, before and after the filter is installed in the machine
    6, LCD, computer host machine communication Interface
    Parameter:
    Entrance temperature:≤45℃
    Handling capacity:0.7-210.0m3/min
    Working pressure:1.0Mpa-42.0Mpa
    Pressure dew point:-50℃
    Regenerative way:heatless regeneration
    Regenerative gas consumption :4-8%(in standard condition)
    Control system:CPU(standard configuration)
    Working system:A、B tower automatic switching,continuous working
    Cycle time :30-90min adjustment
    Condensate water outlet:Rc1/2" (Timing automatic electronic valve )
    Installation: In door installation on no base